Main feature：
The perfect cutting unit has to have the cutting speed is synchronized with the panel conveying speed.
This cutting unit has to be also operated by the manual or automatic control.
The gantry is set at the rear and the saw unit is positioned at the right-hand side as viewed from direction of production. 
The double belt line conveys panel at a pre-adjusted speed.
An incremental encoder is installed at the turning shaft of the double belt measures the length of the endless panel.
The pulses are transferred to the microprocessor control of saw.
The saw waits for the start signal depending on the panel length and then 
accelerates the X-axle to maximum speed so that the speeds of the endless panel and saw are equal.
After synchronization of both speeds and offset control, the clamping units are
pneumatically actuated to clamp the front and back of panel and then saw
carries out the first cut from left to right front direction (traversing).
The cut panel is lying on a non-driven roller conveyor and is pushed out of the operating area of knife by the panel coming from behind.
Saw unit returns to the starting position at a maximum speed. 
At this position saw waits for the next start signal (depending on the length of the sandwich panel) and the above described procedure starts again. 
Operating panel is equipped out of housing and Panel can be automatically cut without worker in case the data of panel length and quantity.
Technical parameters：